Dialogic 6.2 - Manual (Page 187)

Making Call Transfers Using Active Redirection (Japan)
November 2009 187
Making Call Transfers Using Active Redirection
(Japan)
To transfer calls in Japan, use Active Redirection, a call transfer
method that uses the central office or a PBX to transfer calls. Active
redirecting is only available for T1 ISDN PRI and ISDN BRI.
To configure using the
Brooktrout Configuration Tool
(Windows® only):
„ Set port’s
Protocol Options
to
T1 ISDN
or
BRI
.
„ Set the network
Protocol
to
JATE (Japan) INS-1500
.
„ Set the network
Switch Type
to
Japan
.
„ Set the
Transfer Variant
to
Jate ISDN
.
„ Set the
country_code
in
BTCall Parameters
to
0810
.
A list of country codes is in:
C:\Brooktrout\Boston\bfv.api\inc\ccode.h
Note:
You must be in
Advanced Mode
in the
Brooktrout Configuration
Tool
to configure
BTCall Parameters
.
To configure using configuration files:
„ Set the port configuration using the callctrl.cfg configuration file:
port_config=t1_isdn
„ Set the protocol using the callctrl.cfg configuration file:
protocol=ntt
„ Set the switch type using the callctrl.cfg configuration file:
switch_type=ntt
„ Set the transfer_variant using the callctrl.cfg configuration
file:
transfer_Variant=ntt
For ISDN BRI with point-to-multipoint configuration, set:
transfer_Variant=ntt_mp
„ Set the country code using the btcall.cfg configuration file:
country_code = 0810(Japan).
For more information on the
Brooktrout Configuration Tool
, refer to the
chapter on using the configuration tool in the installation and
configuration guide that came with your software.