Dialogic 6.2 - Manual (Page 162)

transfer
November 2009 162
Command Syntax
transfer [options] phonenum
Arguments
phonenum
Caller C’s telephone number.
options
-u unit_num
The unit number to use.
Value: 0 to (max channels-1)
-m b_channel_mode
The channel mode used if the protocol can do 1
or 2 B-channel transfer. If the protocol
supports both, transfer capability is
LINE_XFER_ALL.
Different protocols support different modes:
„
Hookflash supports 1 B-channel transfers.
„
RLT supports 2 B-channel transfers.
„
ETSI BRI, ETSI PRI, T1-ISDN, NTT BRI,
and NTT PRI support both 1 and 2
B-channel transfers.
Values: 1, 2
Note: This option does not support the
LINE_XFER_TWO_CHAN_NEEDS_NAILUP
transfer capability.
-s SUPERVISED mode
prompt_file
Turns on supervised mode.
Value: a valid prompt file.
-t line_state
Transfer is completed at different states while
making the call in unsupervised mode. In
supervised mode, the only state allowed to
complete transfer is BST_CONNECTED.
Value: BST_DIAL_COMPLETE
BST_ALERTING
BST_CONNECTED
-h
If transfer capability is
LINE_XFER_TWO_CHAN, this option puts
the first call on the first bchannel on hold
before making the enquiry call on the second
bchannel.