Altera SerialLite III Streaming MegaCore Function User Manual
Page 54
Signal
Width
Clock
Domain
Direction
Description
phy_mgmt_addr[N:
0]
9 (Stratix V
and Arria V
GZ)
11 - 16
(Arria 10)
phy_mgmt_
clk
Input
Control and status register (CSR) address
for Arria 10 devices.
The width depends on the number of
lanes. The parameter editor determines
the required width for you.
You have to manually tie this extra bit
(4)
:
• phy_mgmt_addr[msb] = 1: for
Transceiver reconfiguration usage.
• phy_mgmt_addr[msb] = 0: for soft
CSR (the transceiver reset and
loopback control CSR)
phy_mgmt_
writedata[31:0]
32
phy_mgmt_
clk
Input
CSR write data.
phy_mgmt_
readdata[31:0]
32
phy_mgmt_
clk
Output
CSR read data.
phy_mgmt_write
1
phy_mgmt_
clk
Input
Active high CSR write signal.
phy_mgmt_read
1
phy_mgmt_
clk
Input
Active high CSR read signal.
phy_mgmt_
waitrequest
1
phy_mgmt_
clk
Output
CSR read or write request signal. When
asserted, this signal indicates that the
Avalon-MM slave interface is unable to
respond to a read or write request.
reconfig_busy
1
phy_mgmt_
clk
Input
For Stratix V and Arria V GZ devices,
when asserted, this signal indicates that a
reconfiguration operation is in progress
and no further reconfiguration operations
should be performed. You can monitor
this signal to determine the status of the
Transceiver Reconfiguration Controller.
For Arria 10 devices, this signal is present
but unused; tie this signal to 1’b0.
(4)
For more information about this bit, refer to the Interlaken PHY Registers table in the Altera Transceiver
PHY IP Core User Guide.
4-30
Signals
UG-01126
2015.05.04
Altera Corporation
SerialLite III Streaming IP Core Functional Description