Altera Avalon Verification IP Suite - Manual (Page 165)

Chapter 1: SOPC Builder Tutorial 1–9
Verifying Avalon-MM Master DUT
May 2011 Altera Corporation Avalon Verification IP Suite User Guide
8. Click Finish.
9. Right-click on the component and select Rename. Rename the component name to
“slave_bfm”.
Connecting and Generating the SOPC Builder System
To connect and generate the SOPC Builder system, follow these steps:
1. Connect the master m0 port to the slave_bfm s0 Avalon slave port using the
following procedure:
a. Click on the master m0 port then hover in the Connections column to display
possible connections.
b. Click on the open dot at the intersection of the slave_bfm s0 port and the m0
port to create a connection.
2. Click Generate. Save the system if you are prompted to do so.
Use the read response signals Off
Use the clken signals Off
Port Polarity
Assert reset high On
Assert waitrequest high On
Assert read high On
Assert write high On
Assert byteenable high On
Assert readdatavalid high On
Assert arbiterlock high Off
Burst Attributes
Linewrap burst Off
Burst on burst boundaries only Off
Miscellaneous
Maximum pending reads 1
Timing
Fixed read latency (cycles) 0
Fixed read wait time (cycles) 1
Fixed write wait time (cycles) 0
Registered waitrequest Off
Registered Incoming Signals Off
Interface Address Type
Set slave interface address type to symbols or words WORDS
Table 1–2. Avalon-MM Slave BFM Parameter Values (Part 2 of 2)
Parameter Value