Altera Avalon Verification IP Suite - Manual (Page 164)

1–8 Chapter 1: SOPC Builder Tutorial
Verifying Avalon-MM Master DUT
Avalon Verification IP Suite User Guide May 2011 Altera Corporation
1. Open the slave_bfm_project.qpf file located in
\ug_avalon_verification\sopc_builder\tutorial_slave_bfm.
2. On the Tools menu, click SOPC Builder.
3. To create the design, in the System Contents tab, expand BFM Tutorial and
double-click Write-Read Master.
4. Retain the default values given in the configuration wizard and click Finish to add
this component to your system.
5. Right-click on the component and click Rename. Rename the component name to
“master”.
6. In the search field located in the Component Library panel, type “Avalon mm
slave bfm”. From the search results, double-click the Altera Avalon-MM Slave
BFM
compoenent.
7. In the parameter editor, change the parameter values to match the values listed in
Table 1–2 .
Table 1–2. Avalon-MM Slave BFM Parameter Values (Part 1 of 2)
Parameter Value
Port Widths
Address width 16
Symbol width 8
Read Response width 8
Write Response width 8
Parameters
Number of symbols 4
Burstcount width 3
Port Enables
Use the read signal On
Use the write signal On
Use the address signal On
Use the byte enable signal On
Use the burstcount signal Off
Use the readdata signal On
Use the readdatavalid signal On
Use the writedata signal On
Use the begintransfer signal Off
Use the beginbursttransfer signal Off
Use the arbiterlock signal Off
Use the debugaccess signal Off
Use the waitrequest signal On
Use the transactionid signal Off
Use the write response signals Off