Pilz PMCprimo DriveP.06/AA0/4/0/0/208-480VAC - Manual (Page 11)

Safety
Operating Manual PMCprotego S2­2(­C)
1002529­EN­02 11
3.1.3 Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by competent persons.
A competent person is someone who, because of their training, experience and current pro­
fessional activity, has the specialist knowledge required to test, assess and operate the
work equipment, devices, systems, plant and machinery in accordance with the general
standards and guidelines for safety technology.
It is the company’s responsibility only to employ personnel who:
} Are familiar with the basic regulations concerning health and safety / accident preven­
tion
} Have read and understood the information provided in this description under "Safety"
} And have a good knowledge of the generic and specialist standards applicable to the
specific application.
3.1.4 Warranty and liability
All claims to warranty and liability will be rendered invalid if
} The product was used contrary to the purpose for which it is intended
} Damage can be attributed to not having followed the guidelines in the manual
} Operating personnel are not suitably qualified
} Any type of modification has been made (e.g. exchanging components on the PCB
boards, soldering work etc.).
3.1.5 Disposal
} In safety­related applications, please comply with the mission time t
M
in the safety­re­
lated characteristic data.
} When decommissioning, please comply with local regulations regarding the disposal of
electronic devices (e.g. Electrical and Electronic Equipment Act).
3.2 Standards
Knowledge of and compliance with the relevant standards and directives are a prerequisite
for using the safety card. The following standards are relevant:
} EN 61326­3­1:2008: Electrical equipment for measurement, control and laboratory use
­ EMC requirements
} EN 61800­3:2004: Adjustable speed electrical drives
} EN 61800­5­2:2007: Adjustable speed electrical power drive systems – Part 5­2: Safety
requirements. Functional
} EN ISO 13849­1:2008: Safety of machinery – Safety­related parts of control systems –
Part 1: General principles for design, Part 2: Validation
} EN 61508:1998: Functional safety of safety­related electrical/electronic/programmable
electronic control systems, Parts 1, 3, 4
} EN 61508­2:2000: Requirements for safety­related electrical/electronic/programmable
electronic systems