HITEC Eclipse 7 Pro - Manual (Page 15)

13
Factory Service Repair Information
Factory Service Repair Information
(for U.S.& Canada only)
Please read the warranty card supplied with your system,
and return it so your system will be under warranty.
Before you decide to have your system repaired, if there
is no apparent physical damage, read this instruction
manual again and check to be sure that you are operating
the system as it is supposed to be operated. If you
are still having trouble, pack up your system in its original
shipping materials and send it to the factory or the nearest
authorized Hitec R/C Service Center.
Be sure to include a note in your package that describes
the trouble in as much detail as possible, including:
Symptoms of the problem in as much detail as you can
provide, including any unusual mounting conditions
or equipment orientation
A list of items you are sending, and what you want to
be repaired.
Your name, address, and telephone number
If you have any questions regarding this product, please
consult with Hitec’s service center. The address and
telephone numbers of our service center is given below.
Telephone inquiries are accepted from 8:00 AM to
4:30 PM weekdays (closed on holidays).
Hitec-RCD, Inc.
12115 Paine St.
Poway, CA 92064
TEL: 1-858-748-6948
FAX: 1-858-748-1767
Changing the Eclipse 7 Pro transmitter’s mode
If you wish to change current system’s Mode from the factory
installed (Mode 2 1, 3 or 4)
Please remove the Transmitter Battery first, after that remove
all backside screws carefully, and then lift back case gently.
In order to change mode , please adjust Tension Screws and
Mode Screws according to below figures.“
Mode
Change
Screw
Mode
Change
Screw
MODE 3 MODE 4
MODE 1 MODE 2
ELEV THRO
ELEV THRO
THRO ELEV
THRO ELEV
AILE AILE
RUDD RUDD
RUDD RUDD
AILE AILE
Web site: http://www.hitecrcd.com