HITEC Eclipse 7 Pro - Manual (Page 5)

3
Hitec 2.4GHz System Set-up
2.4GHz Module Features
The following contains the complete instructions on how to use the Optima 2.4GHz series receivers and Eclipse 7 Pro set for a
trouble free 2.4GHz signal. We encourage you to review this information before using these products.
1. Dual Blue and Red Status indicator LED’s
Indicates the set-up process codes and use status..
2. Function Button
Used for Linking(ID -Setting) the Eclipse 7 Pro to a receiver, entering the power down mode for range checks and the Nomal /
Scan Mode set-up.
3. Sensor Data Output and System Upgrade Connector Port
A 3 pin servo plug connector port is featured on back side of Eclipse 7 Pro . Using the HPP-22 PC interface accessory this
port serves to facilitate upgrading the devices software and downloading information from Optima 7,9 receiver if using
optional onboard sensor station..
1. LED
3. Sensor Date Output &
System Update Port
2. Function Button