EXFO FTB-7000 OTDR Series for FTB-500 - Manual (Page 75)

Testing Fibers in Auto Mode
OTDR 61
7. Select the boxes corresponding to the desired test wavelengths. You
must select at least one wavelength.
8. If you want to clear the settings the OTDR has determined to start with
a new set of OTDR settings, press Reset OTDR Settings.
9. Press Start.
If the first connector check feature is enabled, a message will appear if
there is a problem with the injection level (see Enabling or Disabling
the First Connector Check on page 54).
10. Once the analysis is complete, save the trace by pressing Save in the
button bar.
If you have activated the autonaming feature, the application will use a
file name based on the autonaming parameters you defined
(see Naming Trace Files Automatically on page 50).