EXFO FTB-7000 OTDR Series for FTB-500 - Manual (Page 137)

Customizing the Application
OTDR 123
Defining the Number of Digits Displayed after the Decimal Point
To define the number of digits that will be displayed after the
decimal point:
1. From the button bar, select Setup then select the General tab.
2. Press the Configure button.
3. Modify the number of digits as follows:
3a. Select the desired value from the list.
3b. In the Resolution box, type the desired value or use the buttons
located on each side of the box to adjust the value.
3c. Press OK to confirm your selection.
4. Press OK to return to the main window.