EXFO FTB-7000 OTDR Series for FTB-500 - Manual (Page 101)

Testing Fibers in Advanced Mode
OTDR 87
Selecting the Operation Mode
To select the operation mode:
1. From the main window, press Setup.
2. From the Setup window, go to the Automation tab.
3. Under Operation Mode, select the desired mode.
If you have chosen Auto mode,
³
If you only want one sequence, select Single.
³
If you want to repeat the sequences until you press Stop, select
Infinite.
From the Interval section, in the h box, enter the number of hours
between the sequences. In the m box, enter the number of
minutes.
³
If you want to specify the number of times the sequence will be
performed, select Loop.
From the Interval section, in the h box, enter the number of hours
between the sequences. In the m box, enter the number of
minutes.