Avaya P460 - Manual (Page 94)

Chapter 2 Avaya P460 CLI Commands
84 Avaya P460 Reference Guide
The syntax for this command is:
set outband negotiation {enable | disable}
Example:
set outband speed
User level: read-write, admin.
Use the set outband speed command to configure the speed of Ethernet
Console port.
In auto negotiation mode, the port's speed is determined by auto negotiation. If you
attempt to set the speed when auto negotiation is enabled, the following message is
displayed “Auto negotiation is Enable, can not set the speed
mode.
”
The syntax for this command is:
set outband speed
Example:
enable Enable link negotiation protocol.
disable Disable link negotiation protocol.
P460-1# set outband negotiation enable
Auto-negotiation for outband port set successfully
speed • 10MB
• 100MB
P460-1# set outband speed 100MB
Speed for outband port set successfully