Avaya P460 - Manual (Page 180)

Chapter 2 Avaya P460 CLI Commands
170 Avaya P460 Reference Guide
show snmp
User level: read-only, read-write, admin.
Use the show snmp command to display SNMP information.
The syntax for this command is:
show snmp
Example:
P460-1> show snmp
Authentication trap disabled
Community-Access Community-String
---------------- ----------------
read-only public
read-write public
trap public
Trap-Rec-Address Status Traps Configured
---------------- -------- ----------------
192.138.40.59 Enabled config
fault
trafic_threshold
module_De-Enrollment
module_Enrollment
delete_SW_redundancy_entry
create_SW_redundancy_entry
temperature_warning
general_threshold
cam_change
duplicate_ip
ip_vlan_violation
link_aggregation_connection_fault
link_aggregation_connection_return
link_aggregation_partial_fault
link_aggregation_partial_return
link_aggregation_auto_neg_fault
link_aggregation_auto_neg_fault_return
delete_lag
create_new_lag
active_policy_list_change
policy_access_control_violation
PSU_module_fault
PSU_module_fault_return
fans_module_fault
fans_module_fault_return