Avaya P460 - Manual (Page 63)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 53
necessary.
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate [] [
value>] [ [
[]]]
Example:
ip vlan/ip vlan name
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the ip vlan and ip vlan name commands to specify the VLAN on which an
IP interface resides. You can specify either the VLAN ID using the ip vlan
command or the VLAN name using the ip vlan name command.
The no ip vlan or no ip vlan name command to reset the IP interface to the
default VLAN.
The syntax for this command is:
[no] ip vlan
access-list-number integer (100...199)
priority fwd0 | fwd1 | ... | fwd7
dspc value dscp0 | dscp1 | ... | dscp63
source source ip address
destination destination ip address
protocol ip | tcp | udp | integer (1...255)
source port integer (1...65535)
destination port integer (1...65535)
established value of TCP established bit
Router-1(configure)# ip simulate 100 192.67.85.12
193.76.54.25