Avaya P460 - Manual (Page 41)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 31
The syntax for this command is:
[no] interface
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
ip access-default-action
User level: read-write, admin.
•
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip access-default-action command to set the default action for a
specific policy list.
The syntax for this command is:
ip access-default-action
action>
Example:
ip access-group
User level: read-write, admin.
•
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode.
interface name String (up to 32 characters)
Router-1(configure)# interface marketing
Done!
Router-1(config-if:marketing)#
integer (100...199)
default-action-deny|default-action-permit
Router-1(configure)# access-default-action 101 default-
action-deny