Avaya P460 - Manual (Page 46)

Chapter 2 Avaya P460 CLI Commands
36 Avaya P460 Reference Guide
ip admin-state
User level: read-write, admin.
L You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the admin-state command to set the administrative state of an IP interface.
The default state is up.
The syntax for this command is:
ip admin-state
Example:
ip bootp-dhcp network
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip bootp-dhcp network command to select the network from which
the bootp/dhcp server shall allocate an address. You only need to run this
command is required only when there are multiple interfaces over the VLAN.
Use the no ip bootp-dhcp network command to restore the default value.
The syntax for this command is:
[no] ip bootp-dhcp network
Example:
To select the network 192.168.169.0 as the network from which an address shall be
up/down Administrative state of the interface. The choices are
up
(active) or down (inactive).
Router-1(config-if:marketing)# ip admin-state up
ip-address The IP address of the network.