Avaya P460 - Manual (Page 18)

Chapter 1 Using the CLI
8 Avaya P460 Reference Guide
Avaya P460 Sessions
You can use sessions to switch between P460 Supervisor modules or to switch
between Layer 2 and Layer 3 commands in the P460 CLI.
To switch between P460 modules use the command:
session
[] .
The is the number of the module in the chassis, counting from the top
down. The can be either switch or router. When Module Number is not
specified, the command switches between the modes in the local module. Use
switch
mode to configure layer 2 commands. Use router mode to configure routing
commands.
Example:
To configure router parameters in the module that you are currently logged into,
type the following command:
session router .
L When you use the session command the security level stays the same.