Avaya P460 - Manual (Page 23)

Avaya P460 Reference Guide 13
Chapter 2
Avaya P460 CLI Commands
This chapter describes all the P460 CLI commands and parameters in alphabetical
order.
area
User level: read-write, admin.
L You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the area command to configure the area ID of the router.
Use the no area command to deleted the area ID of the router (set it to 0) and
remove the stub definition.
The default area is 0.0.0.0.
Note: You cannot define a stub area when OSPF is redistributing other protocols or
when the Area ID is 0.0.0.0.
The syntax for this command is:
[no] area []
Example:
arp
User level: read-write, admin.
L You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode.
area id IP address
stub Stub
Router-1 (configure router:ospf) # area 192.168.49.1
Router-1 (configure router:ospf) # area 192.168.49.1 stub