Avaya P460 - Manual (Page 125)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 115
set time client
User level: read-write, admin.
Use the set time client command to enable or disable the periodic network
time acquisition by the switch from the network time server (SNTP or TIME
protocol).
The syntax for this command is:
set time client {enable|disable}
Example:
set time protocol
User level: read-write, admin.
Use the set time protocol command to set the protocol for use in the system as
either SNTP protocol or TIME protocol.
The syntax for this command is:
set time protocol [sntp-protocol|time-protocol]
Example:
enable Enable periodic network time acquisition
disable Disable periodic network time acquisition
P460-1# set time client enable
Time client mode enabled
sntp-protocol Use the SNTP protocol
time-protocol Use the TIME protocol
P460-1> set time protocol sntp-protocol
The protocol has been set to SNTP protocol
P460-1> set time protocol time-protocol
The protocol has been set to TIME protocol