Avaya P460 - Manual (Page 127)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 117
Example:
set vlan
User level: read-write, admin.
Use the set vlan command to configure VLANs.
The syntax for this command is:
set vlan [name ]
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are set.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on module 4.
off
(Optional) Forces the port to become a non-tagging port and persuade
the neighboring port to become a non-tagging port. The
port becomes a non-tagging port even if the neighbor port
does not agree to become a non-tagging port.
dot1q
(Optional) Specifies an IEEE 802.1Q tagging on a Fast Ethernet or
Gigabit Ethernet port.
P460-1# set trunk 3/3 dot1q
Dot1Q VLAN tagging set on port 3/3.
vlan-id vlan number
vlan-name vlan name
P460-1# set vlan 3 name gregory
VLAN id 3, vlan-name gregory created.