Avaya P460 - Manual (Page 53)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 43
ip ospf authentication-key
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip ospf authentication-key command to configure the interface
authentication password.
Use the no ip ospf authentication-key command to remove the OSPF
password.
The syntax for this command is:
[no] ip ospf authentication-key
Example:
ip ospf cost
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip ospf command to configure interface metric.
Use the no ip ospf cost command to set the cost to its default. The default is 1.
The syntax for this command is:
[no] ip ospf cost
Example:
key string (up to 8 characters)
Router-1(configure-if:marketing) # ip ospf authentication-
key my_pass
cost integer
Router-1(configure-if:marketing) # ip ospf cost 10
Done!