Avaya P460 - Manual (Page 44)

Chapter 2 Avaya P460 CLI Commands
34 Avaya P460 Reference Guide
necessary.
Use the ip access-list-copy command to copy a configured source policy list
to a destination policy list.
The syntax for this command is:
ip access-list-copy
Example:
ip access-list-name
User level: read-write, admin.
•
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip access-list-name command to set a name for a policy list.
The syntax for this command is:
ip access-list-name
Example:
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example “new york”.
ip access-list-owner
User level: read-write, admin.
•
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
integer (100...199)
integer (100...199)
Router-1(configure)# ip access-list-copy 100 101
integer (100...199)
list name
Router-1(configure)# ip access-list-name 101 morning