Avaya P460 - Manual (Page 101)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 91
set port level
User level: read-write, admin.
Use the set port level command to set the priority level of a port or range of
ports on the switching bus. Packets traveling through a port set at normal priority
should be served only after packets traveling through a port set at high priority are
served.
The syntax for this command is:
set port level / [value]
Example:
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
value Priority level (0-7)
P460-1# set port level 3/1 5
Port 3/1 level set to 5