Avaya P460 - Manual (Page 47)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 37
allocated for bootp/dhcp requests:
ip bootp-dhcp relay
User level: read-write, admin.
L You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode if necessary.
The ip bootp-dhcp command enables relaying of bootp and dhcp requests to the
bootp/dhcp server.
The no ip bootp-dhcp command disables bootp/dhcp relay.
The default state is disabled.
The syntax for this command is:
[no] ip bootp-dhcp relay
Example:
To enable relaying of BOOTP and DHCP requests:
To disable relaying of bootp and dhcp requests:
ip bootp-dhcp server
User level: read-write, admin.
L You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip bootp-dhcp server command to add a bootp/dhcp server to
handle bootp/dhcp requests received by this interface.
Use the no ip bootp-dhcp server command to remove the server. A
maximum of two servers can be added to a single interface.
Router-1(configure-if:marketing) # ip bootp-dhcp network
192.168.169.0
Done!
Router-1(configure)# ip bootp-dhcp relay
Done!
Router-1(configure)# no ip bootp-dhcp relay
Done!