Set arp-tx-interval, Set boot bank, Set broadcast storm control – Avaya P460 User Manual
Page 83

Chapter 2
Avaya P460 CLI Commands
Avaya P460 Reference Guide
73
set arp-tx-interval
User level: read-write, admin.
Sets the keep-alive frames sending interval. Setting the interval to 0 disables the
transmission of the keep-alive frames.
The syntax for this command is:
set arp-tx-interval
Example:
set boot bank
User level: read-write, admin.
Use the set boot bank command to set the system boot bank (for the active
Supervisor Module).
The syntax for this command is:
set boot bank
{value}
Example:
set broadcast storm control
User level: read-write, admin.
Use the set broadcast storm control command to enable or disable
broadcast storm control.
inband|outband
• Inband – inband interface
• Outband – outband interface
value
The interval in seconds. (0-3600)
P460-1# set arp-tx-interval 15
ARP tx interval was set to 15 seconds.
value
• bank-a to set the boot bank to A
• bank-b to set the boot bank to B
P460-1# set boot bank A
boot bank is A