Avaya P460 - Manual (Page 176)

Chapter 2 Avaya P460 CLI Commands
166 Avaya P460 Reference Guide
in minutes that a PPP session can remain idle before being automatically
disconnected.
The syntax for this command is:
show ppp incoming timeout
Example:
show ppp session
User level: read-only, read-write, admin.
Use the show ppp session command to display PPP parameters and statistics of
an active PPP session.
The syntax for this command is:
show ppp session
Example:
show rmon alarm
User level: read-only, read-write, admin.
Use the show rmon alarm command to display the parameters set for a specific
alarm entry that was set using the rmon alarm command on Page 67 or using the
P460 Manager.
The syntax for this command is:
show rmon alarm []
P460-1> show ppp incoming timeout
PPP incoming timeout is 15 minutes
P460-1> show ppp session
Alarm Index History index defined using rmon alarm command or the
P460 Manager.