Avaya P460 - Manual (Page 126)

Chapter 2 Avaya P460 CLI Commands
116 Avaya P460 Reference Guide
set time server
User level: read-write, admin.
Use the set time server command to set the TIME server address.
The syntax for this command is:
set time server
Example:
set timezone
User level: read-write, admin.
Use the set timezone command to assign a timezone name and sets the time
difference of the device relative to the Coordinated Universal Time (UTC / GMT).
The minutes parameter can only be set to 30.
The syntax for this command is:
set timezone [-][:30]
Example:
set trunk
User level: read-write, admin.
Use the set trunk command to configure the VLAN tagging mode of a port.
set trunk {off|dot1q}
ip address IP address of the TIME server.
P460-1# set time server 192.49.53.68
The Server Ip has been set to 192.49.53.68
zone-name Three-character name of time zone, for example, EST, GMT
hours The difference between the time zone and GMT
P460-1# set timezone EST -5
Timezone set to “EST”, offset from UTC is -5 hours.
module Number of the module (3-6).