Avaya P460 - Manual (Page 85)

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 75
The syntax for this command is:
set device-mode
Example:
L You need to install the appropriate license before you can set the device mode to
Router.
set device-mode (Layer 3)
User level: read-write, admin.
Use the set device-mode command to change the basic mode of operation of the
P460 switch between Router and Layer 2 modes.
The syntax for this command is:
set device-mode
Example:
mode • Router – switch operates at Layers 2 and 3.
• layer2 – switch operates at Layer 2.
P460-1(super)# set device-mode Router
This command will RESET the switch****
Reset **** do you want to continue (Y/N) ?
Done!
mode Router | Layer2
Router-1> set device-mode Layer2
This command will RESET the device
*** Reset *** - do you want to continue (Y/N)? y