Avaya P460 - Manual (Page 106)

Chapter 2 Avaya P460 CLI Commands
96 Avaya P460 Reference Guide
Example:
set port spantree
User level: read-write, admin.
Use the set port spantree command to enable or disable the spanning tree
mode for specific switch ports.
The syntax for this command is:
set port spantree {enable|disable} [module/port]
Example:
set port spantree cost
User level: read-write, admin.
Use the set port spantree cost command to set the cost of a port. This value
defines which port will be allowed to forward traffic if two ports with different costs
switchback-interval The period the primary port link has to be
“up” before the system switches back (in
milliseconds).
• If switchback interval is zero, the system
never switches back
• If it is one, switchback occurs immediately
after the primary port link returns
none The system switches bank only if the
secondary link fails.
P460-1# set port redundancy-intervals 100 20
enable|disable Enables or disables the spanning tree mode for the
specified ports.
Module Module number
Port Port number
P460-1# set port spantree enable 3/1
port 3/1 was enabled on spantree