Philips LCD PROJECTOR - Manual (Page 8)

R emote C ontrol U nit
M(enu)
( i
n BUTTONS
Press the M button to display On-Screen
feature controls. Press A. or ▼ buttons to
move forward and backward through the
list of On Screen items. The menu buttons
can also be used for zoom/ focus (See below).
ZOOM AND FOCUS BUTTONS
The A yf buttons are to control ZOOM.
The - + buttons are to control FOCUS.
You can enable/disable the zoom and focus
controls using the LENS CONTROL
menu (See page 40).
Remote control of zoom and focus is not
possible when the menu is activated (After
pressing M button).
(-•> AND f-h) BUTTONS
Press to select an On-Screen menu item
and adjust settings.
VCR BUTTONS --------------------------------
For use of VCR (Video Cassette Recorder)
buttons see "How to Operate VCRs with
the Projector remote" on page 41.
VOLUME BUTTON
Press to adjust the sound level.
NUMBER BUTTONS
Press these buttons to select TV channels.
Press two number buttons to select single
digit channels. For example: To select
chaimel 6, press “0” first and then “6”.
RESET BUTTON ------------------------------
Selection of 5 personal preference settings
and one Factory preset.
To load the supplied (9 Volt)
battery into the remote:
I BEGIN I
Remove the battery
compartment lid on the back of the
remote.
Place the battery in the remote.
Be sure to line the (+) and (-) ends of the
battery up correcdy.
Reattach the battery lid.
STATUS/EXIT BUTTON
Press to see the current channel number or
source on the Projector screen. Also press
this button to clear the screen after control
adjustments.
MUTE BUTTON
Press to turn the sound OFF on the TV
Projector. Press again to return the sound to
its previous level.
CHannel SCAN BUTTON
Press to scan up or down through the
channel numbers.
•A/CH (Alternate Channel)
BUTTON
1. Press to select the previously-viewed
channel. For example: You are watching
channel 4 and change to channel 10 (usmg
the number buttons). Press A/CH and your
Projector will return to channel 4. Press A/
CH again and your Projector will return to
channel 10.
2. When the Projector is in the DATA
INPUT mode press A/CH to blank the
projected picture with a pre-defined curtain
(See page 53 for details).
TV-VCR-CBL SWITCH
Slide to TV to operate your Projector, slide
to VCR to operate a VCR, slide to CBL to
operate a Cable Converter.
TIMER BUTTON
Set the Projector to turn itself OFF
automatically. See page 52 for derails.
TV-VCR-CBL BUTTONS
Press to turn the TV Projector, accessory
cable converters and VCRs ON and OFF
(See pages 46 thru 48 for details).
Bottom of remote control unit