Remote, How to – Philips LCD PROJECTOR User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How To
S
et
R
emote
to
W
ork
your
C
able
C
onverter
- S
earch
Y
our Projector remote can be set to work
your Cable Converter by what is called the
SEARCH method.
IF the "REMOTE CODE" number method
shown in the previous section did not set your
remote to work your Converter, then follow the
jive easy steps listed below:
Please read throu^ steps I - 5 before beginning.
I
BEGIN
Slide the TV-VCR (Video
Cassette Recorder)-CBL (Cable) switch
to CBL.
Press the POWER button on the
Converter to turn Converter ON.
:
Stand at least six feet away from
the front of the Converter.
Point the remote toward the Converter.
HOLD DOWN the A/CH (Alternate
Channel) and CBL POWER buttons at the
same time. KEEP HOLDING BUTTONS
DOWN.
Watch the Channel Indicator on
die Converter. Channel Numbers will
SCAN UP when the Converter has been
identified. This may take up to two minutes.
POWER buttons as soon as channel
numbers start to scan up. The Converter
code has been identified and the remote is
ready to operate the Converter.
Remember. A minute or two can
seem very long, but the code should be
located within two minutes.
Don't scan more than five channels (in
SEARCH mode) or the two minute search
cycle will have to be repeated.
If no channel change happens within two
minutes, repeat steps 1-5. Should a channel
change still not occur, the remote ■will not
operate the desired Converter.
rv/vcR
A
j
Remote
VCR
© © ©
■ © ® ©
0
©
0 ©
© ® ©
0
( C8L ) ( VCR ) ( TV )
1 _^SiER____I
I RESET
ENTER
Remote
51