How to set remote to work your vcr - search method, Remote, How to – Philips LCD PROJECTOR User Manual
Page 48
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How To
S
et
R
emote
to
W
ork
your
VCR
- S
earch
M
ethod
Y
our Projector remote can be set to work
your VCR by what is caUed the SEARCH
method.
IF the "REMOTE CODE" number method
shown in the previous section did not set your
remote to work your VCR, then follow the five
easy steps listed below:
Please read throu^i steps 1-5 before beginning.
I
BEGIN
I
Slide the TV-VCR (Video Cassette
Recorder)-CBL (Cable) switch
to VCR.
Press the POWER button on the
VCR to turn VCR on.
:
Stand at least six feet away from the
front of the VCR.
Point the remote toward the VCR.
HOLD DOWN the A/CH (Alternate
Channel) and VCR POWER buttons at the
same time. KEEP HOLDING BUTTONS
DOWN.
Watch the Chaimel Indicator to the
VCR. Channel Numbers will SCAN UP when
the VCR has been identified. This may take up
to two minutes.
Release the A/CH and VCR
POWER buttons as soon as channel numbers
start to scan up. The VCR code has been
identified and the remote is ready to operate
the VCR.
Remember. A minute or two can
seem very long, but the code should be located
within two minutes.
Don't scan more than five channels (in
SEARCH mode) or the two minute search
cycle will have to be repeated.
If no channel change happens within two
minutes, repeat steps 1-5. Should a channel
change still not occur, the remote will not
operate the desired VCR.
Remote
TV/VCR
© © ©
W/VCR _
_,
<=) © ©
© ©
© ® ©
©
Remote
48