Philips LCD PROJECTOR - Manual (Page 13)

G
etting
S
tarted
- A
ntenna
/C
able
TV7VCR C
onnections
F irst connect your Antenna or CABLE TV
signal to the Projector. There is only one 75
ohm antenna plug on the ixick of your TV
Projector ' and that's where the antenna goes.
BEGIN I
IF your antenna (or CABLE TV
signal) has a round cable (75 ohm) with a
metal prong (F-connector) on the end,
then you're ready to coimect it to your
Projector.
IF your antenna has flat twin-lead wire (300
ohm), you first need to attach the antenna
wires to the screws on an adapter (300 to 75
ohm).
< 2 > .
Push the round end of the adapter
(or cable) onto the ANTENNA plug at the
back of the Projector.
Make sure the MAIN POWER
button at the rear is switched ON.
Press the POWER ON/STAND BY button at
die front panel to turn the Projector ON. You'll
see a green ligjit above the button and, after about
a minute, you should see a picture on the screen. It
may not be sharp or the size you want, so first you
may have to adjust the picture.
Turn the zoom control until the
picture is the size you want. Then turn the
focus control until it is sharp.
Open the control door (See page 5)
and press the CH(armel) UP button. You
should see local charmels flash by.
I Try it out First make sure your
Projector is properly aimed at the screen. If
you're not sure how to do this, go back and
follow the instructions on pages 10 thru 12.
Remember. If the Projector is
connected to a CABLE TV (CATV) signal, be
sure to set the Projector for that type of signal
(See page 24).
Back of Projector
Focus
Projector Front Panel
Vi,.:......................
13