LAARS NeoTherm NTV1000 - Install and Operating Manual - Manual (Page 71)

NeoTherm Boilers and Water Heaters Page 67
1. From the Home screen (Fig. 82), press the
View Lead Lag button.
fig. 82 – Home Screen
2. If the system were running, the following
screen would normally show the current
activity of each unit in the Lead/Lag system.
See Fig. 83.
fig. 83 – lead/lag Screen
3. To set up the Lead/Lag Master function, press
the button for Lead Lag Master. Fig. 84 shows
the screen that follows.
fig. 84 – lead/lag master Screen
4. Press the Configure button. The display will
present the Lead/Lag Master Configuration
Screen (Fig. 85).
Fig. 85 – Lead/Lag Master Configuration
5. This screen shows the most important settings
for the Lead/Lag system. The settings can be
changed from this screen. Some of them will
require passwords.