LAARS NeoTherm NTV1000 - Install and Operating Manual - Manual (Page 44)

LAARS Heating Systems
Page 40
fig. 37 - Status Summary Page
3. Press the Configure button to start a
configuration session for the selected
controller. See Fig. 38.
Fig. 38 - Configuration Screen
This screen lists all of the configuration
groups. (The list is actually longer – scroll
down using the bar on the right side of the
screen.) Many of the items will not be useful
to an installer or end-user.
4. Next, we will show you how to change one
of these parameters. Let’s turn on the Central
Heat function. On the Configuration Screen
(Fig. 38), scroll down and press the line for
CH – Central Heat Configuration. Figure 39
shows the screen which follows.
Fig. 39 - Central Heat Configuration
On the screen, you can see the Central Heat
function is currently disabled. To turn on the
Central Heat function, press the space beside
CH Enable. The system will tell you that you
must login and enter a password to change this
entry.
5. The process would be the same if you wanted
to change a numerical value, except that
system would present a numeric entry screen.
See Fig. 40.
fig. 40 - numeric entry Screen