Juniper Systems LandMark CE - Manual (Page 64)

64 LandMark CE User’s Manual
Error message:
Could not create shared memory. Method stopped.
The error message appears for the following reason:
An error reserving shared memory has occurred.
To fi x the error do a soft reset and restart LandMark CE.
LandMark CE Mark Point Screen Error Messages
The following are the error messages and suggested fi x for those
messages that may occur when using the LandMark CE Mark Point
screen.
Error message:
Waypoint name can be 30 characters or less. Characters
after 30 will be truncated.
When naming a point, this message appears for the following reason:
The waypoint name is too long and needs to be shortened.
To fi x the problem, shorten the point name to less than 30 characters.
Error Message:
Unable to open data exchange fi le.
This message appears for one of the following reasons:
LandMark CE cannot open or create the data exchange fi le
because the disk is full.
A third party program has the data exchange fi le open.
Fix the problem by either deleting fi les off of the disk, or wait for the
third party program to close the data exchange fi le.
Error message:
Maximum number of waypoints per fi le has been reached.
EXPORT button still available for data export.
Waypoint fi les have a maximum of 256 waypoints per fi le. This
message appears for the following reason:
The maximum number of waypoints has been reached.
The Export button can still be used to export data to another
application, but a new waypoint fi le must be created if extra points
must be stored.
1)
▲
1)
1)
2)
1)