Juniper Systems LandMark CE - Manual (Page 60)

60 LandMark CE User’s Manual
Error message:
Datum not defi ned. Using WGS84 (Default Datum).
This message appears for the following reason:
A programmer changed the datum in the lm.ini fi le. The
new datum value was not valid and is therefore unusable by
LandMark CE. LandMark CE automatically defaults to WGS84
when this happens.
Fix the error by changing the lm.ini fi le datum. See Programmers
chapter for more information.
Error message:
Cannot open LandMark CE registry key.
The registry is a database maintained by the operating system. This
error messages appears for one of the following reasons:
Another program has opened the LandMark CE registry.
LandMark CE did not close the registry properly the last time it
was open.
Another programs wrote a different value to the LandMark CE
registry for this key.
Set Factory Default was executed, erasing the LandMark CE
registry.
Registry errors can be fi xed by doing a soft reset. If the soft reset does
not work, reinstall LandMark CE.
Error message:
Cannot close registry key.
The registry is a database maintained by the operating system where
applications can operate. This error appears for one of the following
reasons:
Another program has opened the LandMark CE registry.
LandMark CE did not close the registry properly the last time
LandMark CE was open.
Possibility that other programs wrote a different value to the
LandMark CE registry.
Set Factory Default was executed, erasing the LandMark CE
registry.
Registry errors can be fi xed by doing a soft reset. If the soft reset does
not work, reinstall LandMark CE.
1)
1)
2)
3)
4)
1)
2)
3)
4)