Juniper Systems LandMark CE - Manual (Page 32)

32 LandMark CE User’s Manual
To
The To box displays the waypoint that is the ending point. This point
is where you intend to stop at once you arrive there.
Waypoint File
Waypoint fi les are fi les consisting of points that have been saved and
labeled. Before the navigation function can be used, a waypoint fi le
must be identifi ed and opened.
When waypoints within the fi le are selected in the From and To
boxes, the Nav screen fi elds update the following:
Compass
Here -> To
From -> To
Quality - Always updated - Current GPS status
Mag Dec - Set value based on Confi guration Settings
Note: If the GPS receiver is not active, only the From -> To box is
updated.
LandMark CE allows having multiple fi les and does not limit how
many waypoint fi les are used. You can log 256 waypoints in each
waypoint fi le.
To open a waypoint fi le, complete one of the following steps:
Tap on File/New to create a new waypoint fi le.
Tap on File/Open to open an existing fi le.
A waypoint fi le is now activated.
Compass
The compass is shown on the left side of the screen. The compass
rotates to show the direction of travel when you start moving. It is
updated when your speed is greater than 0.5 km/hr (0.31 mph).
The arrow is fi xed and always points toward the To location and
assumes the direction of travel is the top of the screen. The compass
body rotates to show the current direction of travel, as long as you
are moving. When you stop, the top of the compass points to the
north.
Here -> To
The Here -> To section of the Navigation screen, shown on the upper
right, displays calculated values based on the current GPS location
(Here) and the destination (To) location.
▲
‰
‰
‰
‰
‰
‡
1)
2)
▲
▲