Juniper Systems LandMark CE - Manual (Page 59)

LandMark CE User’s Manual 59
Error message:
Could not fi nd Ellipse.dat fi le.
Ellipse.dat fi les are datum fi les saved in the registry. This error
message appears for one of the following reasons:
The registry is corrupt, or a Set Factory Default was executed.
The program path was modifi ed, so the registry path is no longer
available.
The ellipse.dat fi les were deleted.
To solve the problem, check the registry path. Registry errors can be
fi xed by doing a soft reset. If the soft reset does not work, reinstall
LandMark CE.
Error message:
Error Initializing WMM2K - WMM.COF File not found.
WMM is a formula used to calculate magnetic declination from GPS
data. Most receivers do this calculation, but some do not. In the
instance that a receiver does not calculate magnetic declination, you
need to use either Manual Mode, or WMM 2K for calculations.
The error message appears if the WMM.COF fi le cannot be found.
The following are reasons for not being able to fi nd the fi le:
The registry is corrupt, or a Set Factory Default was executed.
The program path was modifi ed, so the registry path is no longer
available.
The WMM.COF fi le was deleted.
The date setting on the Allegro precedes the year 2000.
Registry errors can be fi xed by doing a soft reset. If the soft reset does
not work, reinstall LandMark CE.
Error message:
lm.ini File not found - Default values used.
The lm.ini fi le is where LandMark CE’s specifi cations are written.
This message appears for one of the following reasons:
The registry is corrupt, or a Set Factory Default was executed.
The program path was modifi ed, so the registry path is no longer
available.
The lm.ini fi le was deleted.
Registry errors can be fi xed by doing a soft reset. If the soft reset does
not work, reinstall LandMark CE.
1)
2)
3)
1)
2)
3)
4)
1)
2)
3)