Juniper Systems LandMark CE - Manual (Page 33)

LandMark CE User’s Manual 33
Distance
The Distance box displays the distance in the selected current units
(meters or feet) from the Here to the To location.
Bearing
The Bearing box displays the compass heading in degrees from Here
to the To location.
Track
The Track box displays the direction you are traveling in degrees.
Speed
The Speed box displays the speed you are moving in current display
units (km/h or mph).
XTE
The XTE box gives the shortest distance between the current
location of the GPS receiver and the line that connects the From
and To locations. A positive (+) XTE is to the right of the path and a
negative (-) XTE is to the left, meaning you are traveling toward the
To location.
From -> To
The From -> To section of the Navigation screen displays calculated
values based on the From location to the To location. When changing
From or To waypoints, displayed information in the Here -> To section
may not be updated until you start moving; this can depend on the
GPS receiver being used.
The From -> To section is updated even without receiving GPS signal.
Once the From and To waypoints are selected, the values in the From
-> To section do not change.
Distance
The Distance box displays the distance in current units (metric or
standard) from the From location to the To location. The distance
converts to miles or km when the distance reads high enough that it
applies.
Azimuth
The Azimuth box displays the compass heading in degrees from the
From location to the To location.
Quality
See GPS quality status explanations located earlier in this section.
▲
▲