Juniper Systems LandMark CE - Manual (Page 30)

30 LandMark CE User’s Manual
Sat #
Sat #, or SV number, indicates the satellite vehicle, or space vehicle
number.
Azimuth
Azimuth is the bearing measurement in degrees from North that
represents the horizontal direction of the satellite from the current
position.
Elevation
Elevation is shown in degrees and is the angular measurement
above the Azimuth line, which gives the satellite’s height above
the horizon. A satellite located lower on the horizon has a lower
elevation in degrees.
SNR
SNR is the Signal to Noise Ratio, or the ratio of signal received to
noise received. More signal, or higher number, indicates a stronger
signal strength. More noise indicates less signal strength.
Used
Used is the status of the satellite’s signal in calculating the current
location. If the satellite signal is picked up by the receiver, but the
signal is not strong enough, or if the satellite is not benefi cial to
use due to poor geometric arrangement, it is not used for position
calculation. Yes indicates that the satellite’s data is being used to
calculate your position. No indicates that the satellite’s data is not
being used to calculate your position.
Freeze/Unfreeze
The button title automatically toggles between Freeze and Unfreeze
depending on your selection. The button title displays the action
that occurs when the button is tapped. The Freeze button captures the
Packet Info (data stream) instantaneously from the GPS receiver. Tap
Unfreeze to return to the continuous data stream mode.