Juniper Systems LandMark CE - Manual (Page 58)

58 LandMark CE User’s Manual
Error and Warning Messages
LandMark CE displays pop-up messages when an error occurs.
The following section lists the possible error messages and suggests
how to fi x the problems related to an error message.
LandMark CE Startup Error Messages
The following are the error messages and suggested fi x for those
messages that may occur during LandMark CE startup.
Error message:
Application Path Not Found. Please make sure the path
‘C_Drive\C_Program Files\LandMarkCE’ exists. If it does
not, please re-install LandMark CE.
This error message appears for one of the following reasons:
The path, C_Drive\C_Program Files\LandMarkCE, (the
LandmarkCE default installation path), was changed after
installation.
You tried to copy the Landmark CE folder from another Allegro.
You must use the installation CD to set the path where the
LandMark CE is installed on the Allegro.
A factory default reset on the Allegro was performed; LandMark
CE is still saved in the C_Drive, but the registry has been erased.
To fi x the error, reinstall LandMark CE.
Error message:
Error initializing datums. If “3_param.dat” and “7_param.
dat” fi les are corrupt, re-install, or check for correct
application path (\C_Drive\C_Program Files\LandMarkCE).
When LandMark CE is installed, datum fi les are saved in the registry
as 3_Param.dat, and ellipse.dat. This error message appears for one of
the following reasons:
The registry is corrupt, or a Set Factory Default was executed.
The program path was modifi ed, so the registry path is no longer
available.
The 3_Param.dat, and ellipse.dat fi les were deleted.
Fix the error by either checking the registry path, or reinstalling
LandMark CE.
▲
1)
2)
3)
1)
2)
3)