Juniper Systems LandMark CE - Manual (Page 54)

54 LandMark CE User’s Manual
Check the Offset On check box, after these fi elds are fi lled in,
if you want the offset calculations activated before closing the
waypoint.
Now, whenever you select the saved offset point, if the Offset On
check box is checked, an indicator appears in the Waypoint screen
while viewing the point information.
If you want to view the unaltered point information, tap on the Edit
button in the Waypoint screen.
Offset values are activated automatically when saving/closing the
waypoint by tapping on the OK button. The Cancel button does not
save any of settings or impose the new offsets.
Average
The Average button is used to average GPS fi xes that pass the mask
settings. When you press the Average button, the bar graph above
starts to fi ll, showing a ratio of points that have been included in the
average so far.
The status/quality of GPS averaging is displayed in the box to the
left. If a reading is masked, the reason for being excluded from the
average is displayed in the box to the left.
The running and fi nal averaged information is located to the left of
the Average button. While a waypoint is being averaged, the average
button displays Averaging.
If the Store Wpt button is pressed during the averaging process, the
fi nal average is not stored until all the points specifi ed to compute
the average have been included. (Notice how the Store Wpt button
shows waiting while still averaging). Similarly, fi nal data cannot be
exported until averaging is complete.
Store WPT
The Store WPT (Store Waypoint) button is used to store an average
waypoint in the current waypoint fi le. If the Store WPT button is
pressed before the Average button (if the button is available), the
averaging process begins automatically and continues until all points
for the average have been obtained. After the point is averaged it is
stored in the waypoint fi le.
In both cases, after the averaged waypoint is stored, the Mark
Point screen will close. The new waypoint is included in the list of
waypoints on the left side of the Waypoint screen.
4)