Interlogix Monitor XL Advanced Installation Guide User Manual
Page 47
21-3602E rev1.5
Monitor xL™ Advanced Installation Guide
41
European Version (Area)
63 Siren
64 Confirmed
Alarm
Strobe
65 Fire
66 Personal
Attack
67 Unconfirmed
Alarm
68
Set / Unset
69
Freezer / Fire Fault
70
Bypass in Effect
71 Confirmed
Alarm
Program Section (“q”)
“P”oint (
Inputs)
Section Range (“nnn”)
Enter 001 – 128
Code
“cc”
Description
00
When point is NORMAL.
01
Any time the point is NOT NORMAL
(open, tamper, alarm)
02
When point is NOT NORMAL in OFF or
STAY (open, tamper, alarm)
03
When point is NOT NORMAL in ON
(open, tamper, alarm)
04
When point is in ALARM
05
When point is BYPASSED
06
When the time delay is active (Pre-alarm
Warning).
07
Point is in Tamper.
08
Point is in Delay. Follows a Custom Pt
Type that has a time delay.
09
Positive confirmation of Command Point
activation.
Program Section (“q”)
“B” Output State
Section Range (“nnn”)
Enter 001 – 128
Code
“cc”
Description
00
An actual output is on.
01
Equation Output is TRUE
02
Manual Command is in effect from the
Director software Outputs Section,
Control & Status.
WARNING: Access Control related outputs can only be used with
the addition of the “Feature Expansion Board”.
Program Section (“q”)
“R” Doors
Section Range (“nnn”)
Enter 001 – 032
Code
“cc”
Description
00 Door
Unlocked
01 Door
Locked
Out
02 Door
Held
Open
03 Door
Forced
04
Door Tamper (door contact condition: no
EOL resistor etc.)
05 Door
Open
06 Door
Secure
07
Door Sensor Trouble (magnetic bond
sensor not ok)
08
Door Blocked by Interlock Condition
09
Wandering Patient Detected
10
Door entry Delay in Effect
Program Section (“q”)
“F” loors
Section Range (“nnn”)
Enter 001 – 124
Code
“cc”
Description
00 Floor
Desecure
Program Section (“q”)
“M” odule
Section Range (“nnn”)
Enter 01 – 24
Code
“cc”
Description
00 On
Line
01 Tamper
02
Comms Trouble (Substitution & Comms)
03 Battery
Trouble
(Module)
04
User logged on to e.g. LCD keypads
Program Section (“q”)
“C” Suite
Section Range (“nnn”)
Enter 01 – 24
Code
“cc”
Description
00 Alarm
01 Fire
02 Tamper
03 Siren
/
Sonalert
04
Module Communications Trouble
05
Suite Normal (No Alarm, Fire, Tamper,
Siren / Sonalert, Comms Trouble)
06
Suite in STAY level.
07
Suite in ON level.
08
Suite in STAY or ON level.