Interlogix Monitor XL Advanced Installation Guide - Manual (Page 18)

12 Monitor xL™ Advanced Installation Guide 21-3602E rev1.5
S00403 Secondary Card Format—Basic Settings
Keypad Selections
(left to right on keypad screen) Example:
Default Name
Selections Description
10 ID Number
Position 1 – 40 The position of the 1st digit for the
ID number on secondary-format
access tokens.
16 ID Number
Length 1 – 32 The length of the card ID-number for
secondary-format tokens.
26 No. of Bits /
Chars 1 – 40 The total number of bits (Wiegand)
or characters (Magstripe) in the card
data.
8 Bits per
Character 1 – 8 The number of bits used to
represent each character (for
magnetic stripe cards).
2 Card/Token
Format 0=none, 1=future (dallas), 2=weigand, 3=mag The basic type of card or token
associated with the secondary card
format settings.
32-Bit / 9-Digit Card IDs: This requires V1.5 door/elevator controller firmware.
S00404 Secondary Card Format—Odd-Parity Checking
Keypad Selections (left to right on keypad screen)
Default Name
Selections Description
26 Odd Parity Position 1 – 40 The position of the odd-parity 'checksum'.
14 Odd Parity Start 1 – 40 This is the position of the first data-bit to be included for odd-parity
checking.
12 Odd Parity Length 0 – 40 If either the odd parity length = 0 or even parity length = 0, then parity will
not be checked.
Odd/Even Parity checking: This feature (which applies only to Wiegand-format cards) helps prevent card misreads.
To disable parity checking: Set the 'Parity Length' to 0 (zero).
S00405 Secondary Card Format—Even-Parity Checking
Keypad Selections (left to right on keypad screen)
Default Name
Selections Description
01 Even Parity Position 1 – 40 The position of the even-parity 'checksum'.
02 Even Parity Start 1 – 40 This is the position of the first data-bit to be included for even-parity
checking.
12 Even Parity Length 0 – 40 This is the number of bits to be included for even-parity checking.
Odd/Even Parity checking: This feature (which applies only to Wiegand-format cards) helps prevent card misreads.
To disable parity checking: Set the 'Parity Length' to 0 (zero).
10 · 16 · 26 · 8 · 2 ····

Save S004

03