Interlogix Monitor XL Advanced Installation Guide - Manual (Page 10)

4 Monitor xL™ Advanced Installation Guide 21-3602E rev1.5
S00104 Keypad Selections
(left to right on keypad screen) Example:
Default Name
Selections Description
00 Confirmed Alarm Time
Out Time table codes. (UK ACPO = 18)
0 Maximum Number of
Alarms per Point
Arming State 0 = All, 1 = 1, 2 = 2, 3 = 3 Primarily for
European Users. (UK ACPO = 3)
0 Menu Navigation 0 = Standard, 1 = Ok-SOFT-3, 2 = Ok-
SOFT-1, 3 = future.
0 LCD Menu Style 0 = Standard, 1 = Ok-SOFT-3, 2 = Ok-
SOFT-1, 3 = future.
0 Unconfirmed Reset
Mode 0 = None, 1 = Follow Confirm Alarm, 2 =
Include Master, 3 = future.
 (no) Confirm Reset Service 
(yes)
□
(no)
(UK ACPO = yes)
 (no) Confirm Reset Master 
(yes)
□
(no)
 (no) Confirm Reset
Challenged PIN. 
(yes)
□
(no)
 (no) Confirm Reset using
Remote 
(yes)
□
(no)
S00105 Keypad Selections (left to right on keypad screen)
Default Name
Selections Description
01100 AC
Reference
Voltage – Main panel electrical mains operation.
E.g. 01100 = 110.0 Decivolts
(UK ACPO = 02200)
070 Battery
Size Amp hours X 10
E.g. display as 7.0 (UK ACPO = 17.0)
0 AC Sync 0=60 Hz, 1=50 Hz, 2=No sync required,
3=DC supply Synchronization with AC line to maximize internal clock
accuracy. With an unstable AC source, select "2: AC-
No Sync" ('AC failure' will be reported if the frequency
drops below 12.5 Hz). With a DC source, be sure to
disable E003 (AC Trouble) under "Equipment
Settings".
DC supply option will not detect power failure condition
and will not have a time base sync
(UK ACPO = 1)
0 AC
Brownout
Mode 0=None, 1=Local alarm, 2=Alarm+report,
3=Report only
S00106 Keypad Selections (left to right on keypad screen)
Default Name
Selections Description
001 VBUS Panel Output Base See: Main Panel Output
Examples: next What number the outputs that will be used on
the main controller’s VBUS connection will
start at.
001 Paging Output Base See: Main Panel Output
Examples: next What number the outputs that will be used on
the paging system will start at.
Also see S005:08, 09
001 Output Base for:
World Wide Modem with 8 output STU
REDCARE interface or 8 output STU
REDCARE interface
STU = Subscriber Terminal Unit
See: Main Panel Output
Examples: next What number the outputs that will be used
with the main control board output plug in
boards will start at.
(UK ACPO = 003)
00 · 0 · 0 · 0 · 0 ·     ·

Save S001

04