Interlogix Monitor XL Advanced Installation Guide - Manual (Page 35)

21-3602E rev1.5 Monitor xL™ Advanced Installation Guide 29
M0xx07 Keypad Selections Note: “xx” represents the module number.
WARNING: These Access Control features are only available with the addition of the “Feature Expansion Board”.
(left to right on keypad screen) Example:
Pressing the keypad button under 
?
will display the type of module and the module’s input and output ranges.
Default Name Selections Description
 (no) Reader Defined 
(yes) □ (no)
000 Card Lockout Schedule 00 = No scheduled
lockout
01 – 250 Schedule
A schedule to specify when card access will be blocked
0 Enable or Disable
Cards of Type 0 = None
1=Escort Req’d
2 =non-permanent
users. 3 =all users
0 Enable or Disable
Mode If enabling reader,
see Note *1 .
If disabling reader,
see Note *2 . Note *1: If enabling reader, 0=enable for 4 hrs, 1=enable for
8hrs, 2=enable for 12 hrs, 3=enable for 24 hrs, 4=enable for
1 week, 5=enable until midnight tonight, 6=enable
permanently, 7=enable until out of schedule according to
schedule 50.
Note *2: If disabling reader, 0=disable card permanently,
1=disable card but set it so that it can be re-enabled later at
an enabling station, 2= disable card permanently and trigger
auxiliary output , 3= disable card enable re-enroll and trigger
auxiliary output, 4 to 7 = not used, same as 1 (room for
future expansion)
 (no) Arming Station or
Keypad Reader
connected to Reader
LCD Keypad 
(yes) □ (no)
NOTE: Bi-colour LED must be enabled for command station
R0017.
 (no) Lockout In Schedule 
(yes) □ (no)
Toggles the lockout between inside of the chosen schedule (

), compared to outside of the schedule ( □ ).
 (no) Enabling Reader 
(yes) □ (no)
 · 000 · 0 · 0 ·  ···

Save

? M001

07