Making a multi-track recording, Init drive (initialize drive), Parameter – Roland 24 bit Digital Studio Workstation VS-890 User Manual

Page 70: Timea^alue dial, Physical fmt fphysical format), Partition, As needed, use, And the, Svsphysicalfnt= off, Svs p.artition=1000mb -ds

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Making a Multi-Track Recording

Init Drive (Initialize Drive)

Select the disk drive (IDE, SCSI0-SCSI7). "The internal hard disk will be

shown as "IDE," and external disk drives will be shown as "SC0-SC7." The

number following each disk drive indicates the partition number.

5 8

If you accidentally delete

data that you need, that

data cannot be restored to

its previous condition.

Roland Corporation

assumes no liability

concerning such loss of

data.

When a single hard disk or

other disk is divided into

partitions,

it is no possible

to initialize only an

individual partition.

The

Drive Initialize operation

wiU be performed on all

partitions of that disk drive

or other disk.

As needed, use

PARAMETER [ ◄◄ ] [ ►► ]

and the

TIMEA^ALUE dial

to make the following settings.

CONDITtON MARKER#

SVSPhysicalFnt= Off -

lEASURE BEAT

Physical Fmt fPhysical Format)

Select

whether

not

use

physical

formatting.

normal

circumstances,

set this to "Off." If a disk error is found with Surface Scan (p. 72), set this to

"On," then initialize the hard disk again.

CONOmON MAF«

SVS P.artition=1000MB -ds

BEAT

Partition

Select the partition size (500 MB or 1000 MB). In normal circumstances,

select "1000 MB."