Preparations, Required preparations, Installing an internal hard disk (hdp88 series) – Roland 24 bit Digital Studio Workstation VS-890 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Preparations
Required Preparations
The
VS-890
is
an
audio
recorder
that
allows
multi-track
recording
to
a
hard
disk.
To
make
a
multi-track
recording,
you
will
need
at
least
the
following
items.
• VS-890 (1 unit)
• Power cable (1: included)
• Internal IDE hard disk (HDP88 series: sold separately in some countries)
• Audio device for master output or headphones (sold separately)
• Microphone or other audio source to record, such as an electric guitar,
synthesizer, or CD player etc. (sold separately)
User
Guide
will
also
explain
the
use
of
the
following
equipment,
which
you
may purchase as desired.
• External CD-RW drive (designated by Roland, sold separately)
Installing an Internal Hard Disk
(HDP88 series)
Cautions Concerning Installation of Hard Disk Drive
• Always turn the unit off and unplug the powder cord before attempting
installation of the hard disk drive unit (model no. HDP88 series; User
Guide p. 14).
• Install only the specified hard disk drive unit (model no. HDP88 series).
Remove only the specified screw^s.
• To avoid the risk of damage to internal components that can be caused
by static electricity, please carefully observe the following w^henever you
handle the hard disk.
•
Before you touch the hard disk, always first grasp a metal object (such
as a W'ater pipe), so you are sure that any static electricity you might
have been carrying has been discharged.
•
When handling the hard disk, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
•
Save the bag in w’hich the hard disk w^as originally shipped, and put
the hard disk back into it whenever you need to store or transport it.
• Use a Phillips screwdriver of a size appropriate for the head of the screw
(a no.2 screwdriver). If the screwdriver is the wTong size, the screws
heads may be stripped, or you may not be able to turn the screws.
• To remove the screw^s, rotate the screwdriver counterclockwise. To
tighten the screws, rotate the screw'driver clockwise.
• Take care not to drop any screw's into the interior of the VS-890's chassis.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Never use excessive force w'hen installing a hard disk. If it doesn't fit
properly on the first attempt, remove the hard disk and try again.
• When hard disk installation is complete, double-check your w'ork.
The explanations in this
manual include
illustrations that depict
w'hat should typically be
shown by the display.
Note, however, that your
unit may incorporate a
newer, enhanced version of
the system, so wliat you
actually see in the display
may not always match
what appears m the
manual.
loosen f .
tighten