Roland 24 bit Digital Studio Workstation VS-890 - Manual (Page 62)

Making a Multi-Track Recording
Rotate the TIME/VALUE dial to select equalizer "On."
EQ Switch (Equalizer Switch)
If you wish to use the equalizer, set this "On." If not, set this "Off." When
equalizer settings are being made, the equalization curve will be shown
graphically in the bar display. If this is "Off" the equalizer-related
parameters will not be available. For this example, select "On" so that the
equalizer will be applied.
] and Use PARAMETER [◄◄],[►►],[◄],[ I
TIMEA/ALUE dial to make the setting.
EQL (Equalizer Low)
This adjusts the gain (-12 to 12 dB) and the center frequency (40 Hz to 1.5
kHz) of the low-range (shelving) equalizer.
CO^OmON MAWER*
TRl EQL
MEASURE BEAr
1 1
SYNC MODE SCENE
I NT-----
REUMWNQ TtUE
294.400.1
- 6dB.-; 200Hz
t 2 3 4 - s e 7 e A B U n
If you adjust the equalizer
while sound is playing, you
may notice "blips" in the
sound. This is not a
malfunction. If you find it
annoying, adjust the
equalizer when the sound
is not playing.
J@>
The screens will change
when you press
PARMETER [ ◄◄ 1,
I ►► ]. Press [ ◄ ] ,
[ ► ] to access the
parameter (gain or
frequency) that you wish to
adjust.